This icon (which looks like two angled arrows facing opposite directions) may be selected to reverse the direction of the extrusion as it originates from the sketch. Sometimes when we enter the extrude command, we discover that the extrusion is going the wrong direction.
![do circular pattern in solidworks with nterference merge bodies do circular pattern in solidworks with nterference merge bodies](https://i.pinimg.com/originals/96/ac/83/96ac8366cb11f38ef852befeb162365d.jpg)
The “Reverse Direction” OptionĪnother important tool in the extrude command is the ability to reverse the direction of the extrusion.įigure 3.An example of a sketch being extruded blind in the default direction (above) and the same sketch being extruded blind with reverse direction enabled (below). In this case, we chose to go 20mm in Direction 1, which is up, and 7.5mm in Direction 2, which is down.Įach of the end conditions and options that are available in Direction 1 will be available in Direction 2 (with the exception of “Mid-Plane”), so as you read through this blog, remember that each of the options I describe for Direction 1 will be available to you if you choose to use Direction 2.
![do circular pattern in solidworks with nterference merge bodies do circular pattern in solidworks with nterference merge bodies](https://i.ytimg.com/vi/K0fJA1R9luQ/maxresdefault.jpg)
Oftentimes when creating solid models, we need an extrusion to go a certain distance in one direction and a different distance in the other direction. An extrusion with Direction 2 selected, with an end condition set to “Blind” and a distance of 7.5mm in Direction 2.įigure 2 shows the same extrusion as Figure 1, but with the checkmark for Direction 2 selected. The “Direction 2” OptionĪnother common option for an extrusion is to extrude the sketch in two different directions.įigure 2. Again, this is known as a “blind” end condition. So the condition for ending the extrusion is that it will proceed a set distance and then stop. After that distance is met, extrusion will stop. The default end condition is “blind,” which means we will take our sketch and extrude it a set distance from the sketch plane. We then begin the extrude command and choose an end condition from the pull-down menu. In Figure 1, we can see that the sketch has been created as a rectangle with the dimensions 40mm x 100mm. An extrusion with the end condition set to “Blind” and the distance set to 20mm. The end condition can be thought of as the parameter or rule that causes the extrusion to stop.įigure 1. One of the first things to learn about the extrude command is the concept of the end condition. The Extrude Boss/Base command in the Features toolbar. In today’s blog, we will review and break down some of the great tools available in each section of the extrude command. Every few releases, this feature gets some terrific functionality added to it. An Extruded Boss/Base feature will allow you to take a 2D sketch and add thickness to it in the third dimension.
![do circular pattern in solidworks with nterference merge bodies do circular pattern in solidworks with nterference merge bodies](https://i.ytimg.com/vi/4mFW343QkHI/maxresdefault.jpg)
Do circular pattern in solidworks with nterference merge bodies software#
One of the oldest commands in the SOLIDWORKS software is the boss/base extrude command.